FRP industry application introduction:
FRP, resin products, sandblasting machine, mold removal, wax removal, passivation effect is better than manual grinding, saving labor 20 times, and increasing efficiency 40 times!
Sandblasting of glass fiber reinforced plastic products and resin products using a sandblasting machine can quickly clean up the wax attached to the surface after demolding, passivate the surface of the product, increase roughness, and make subsequent spray painting, increase the adhesion of batch powder, and life Improve 3-5 times.
After experiments, you can save 20 times labor and increase efficiency 40 times.Case: A face-size glass fiber reinforced plastic mask model, manual polishing with a hand mill takes 5-8 minutes, while using a sandblaster takes about 10 seconds, If the one-person pressure sandblasting machine produced by Meijun sandblasting equipment is used, the efficiency will be higher, which can save a lot of labor and increase the efficiency of product molding.
At the same time, the pressure-relief automatic exhaust sand blasting machine produced by Meijun is safe to use, generates air pressure when it is turned on, and removes the air pressure when it is stopped. All operations are controlled by only one person through the control switch on the hand. Welcome to understand!