Routine maintenance and maintenance methods;
1.Sandblasting pipeline and gas path
Inspect the blast hose for damage and replace it immediately. Check the connection for firmness and eliminate any leaks immediately.
Inspect the trachea for damage, wear, and connections to ensure that each joint is properly sealed, and if worn, replace it immediately.
Every day and after work, check the honeycomb floor for large impurities, and if so, remove it.
3. Artificial respirator
Before commuting, check whether the protective glass of the respirator is damaged or affects the processing operation. If affected, replace it immediately. Ensure personal safety; check the air filter and air supply of the respirator to ensure normal air supply.
Because the protective clothing glass is fragile, it should be handled lightly during sandblasting operations, do not touch it, and it should be kept stable when not in use.
4, spray gun, nozzle
Inspect the gun and nozzle for wear, and replace them immediately if they are severely worn or if the efficiency of the blasting process is noticeably reduced.
As the spray head, protective clothing glass, spray gun switch and other parts are fragile, you should hold it gently during blasting operation, do not shake and touch, and keep it steady when not in use.
5.Sand adjustment valve
Check that the adjustment lever is worn and must be replaced beforehand.
6, protective rubber in the room
Inspect the rubber in the room for damage and replace it as appropriate.
7, door safety switch, gun switch
Check whether the gate control safety switch and spray gun switch are sensitive and effective. If the action fails, they should be repaired immediately.
Check the seals, especially the door seals, and replace them immediately if found to be invalid.
Check whether the operation control buttons of each device are normal. If abnormalities are found, they should be fixed immediately.
Check the use of protective glass, ballasts and bulbs for the luminaire.
11.Filter dust box gray box
Remove dust from filter dust box and separator ash box before work